How Do I Install a Chimney Liner?

Information may not be reliable

If you’ve been looking for a way to make sure that you are able to use your chimney without any issues, then you may consider getting your chimney replaced or repaired. The fact of the matter is, you don’t have to spend a lot of cash when it comes to getting your chimney to a point where it is safe to use. A chimney liner installation can, in fact, make it so that your chimney is safe to use again, and it’s fairly easy to install and set up one of these devices.
 
The chimney liner is a stainless steel item, that basically helps to decrease the chances of leaks, buildup, and other problems which could be a health hazard to your family. These liners look like giant pipes that go into your chimney, and once you get them in there, you can’t even tell that there’s something in your chimney. They’re that unique. They’re easier to clean (since they’re stainless steel and not brick), and they can be replaced a lot more easily than the entire chimney. Why waste all that time and effort when you can do the whole process for a lot less?

The first step in getting a chimney liner installation completed is by finding the right one. Everyone’s chimney is a different size, and so you want to make sure that you get the right measurements for the chimney ahead of time. It, basically, has to be the same size as the exhaust hole that the smoke would come out of typically. You can easily find this size by measuring the diameter of this hole. Then, you can use that as a measure for the diameter of the chimney liner that you are going to purchase and install.

Then you just need a knife, a caulking gun, gloves, a screwdriver, a power drill, and glasses to keep your eyes safe. The kit will have everything you need inside of it; the liner itself, the cap for rain, the plate that you put on top of the chimney, and all of the connectors that will hold the liner to the chimney itself. The liner may be a little heavy, but honestly, the job really isn’t as large or difficult as you may think.

The first step is to straighten out the liner, since it usually will come to you coiled up like a snake. Inspect the entire liner for any holes (on rare occasions, they can end up getting holes during processing or delivery), and then take it to your chimney. You, essentially, have to snake the whole liner down the hole. The bottom tee connection that is attached to the liner is going to go into the flue first, and then you just have to make sure it goes down. Do this slowly – if the liner scrapes up against the sides of the chimney, it could end up getting damaged, and if it does it’s not going to do its job very well.

Then, all you have to do is make sure that you connect the lower tee connection to the stove pipe, and then attach the plate on top to the top of the liner. Use some calking to calk the plate onto the top of the chimney, and then install the rain guard on top of that. This is, perhaps, the most difficult part of the entire chimney relining  installation. You have to be careful and precise so that you don’t leave any gaps, but at the same time, it’s relatively easy to check your work when you’re done.

So, if you’ve been trying to get your chimney repaired, and you were intimidated by the potential cost of doing so, then you may want to consider doing a chimney liner installation. Even if you don’t feel incredibly comfortable doing it on your own, you can find a chimney professional to come in and take care of it for you. Their prices are reasonable and they will be able to ensure that your chimney is safe and ready to go the next time that you want to light a fire in there on a cold winter’s night.

For more info about hancock chimney sweep services  visit here

Source: Click Here